Physics, 20.10.2020 02:01 ansatsai

An object has an acceleration of +5.0 m/s^2. What does this mean?

Answers: 3

Show answers

Other questions on the subject: Physics

Physics, 21.06.2019 21:30, queenkimm26

Look at the potential energy diagram for a chemical reaction. which statement correctly describes the energy changes that occur in the forward reaction?

Answers: 1

continue

Physics, 22.06.2019 07:00, jeremiahphillip4396

The speed of sound in ice, water, and steam is shown. what best explains the speed of sound in different states of matter? sound travels fastest in ice because energy is easier to transfer when the molecules are close together. sound travels slowest in steam because the sound has to move around the gas molecules that are far apart. sound travels fastest in ice because the temperature of solids is always greater, so the heat transfers the sound energy. sound travels slowest in steam because the pressure is so great the sound cannot travel though the steam particles.

Answers: 1

continue

Physics, 23.06.2019 02:30, monkemily1

An airplane is flying with a velocity of 240 m/s at an angle of 30.0∘ with the horizontal, as the drawing shows. when the altitude of the plane is 2.4km, a flare is released from the plane. the flare hits the target on the ground. what is the angle θ?

Answers: 3

continue

Physics, 23.06.2019 07:00, hockejoh000

Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater. what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?