Physics, 08.09.2020 18:01 kms275

What is power, and what is its relationship to voltage and amperage?

Answers: 2

Show answers

Other questions on the subject: Physics

Physics, 21.06.2019 15:30, toxsicity

The four giant gas points that are made primarily of lightweight elements are

Answers: 3

continue

Physics, 21.06.2019 18:30, iliketurtures

Three archers each fire four arrows at a target. joe’s four arrows hit at points 10 cm above, 10 cm below, 10 cm to the left, and 10 cm to the right of the center of the target. all four of moe’s arrows hit within 1 cm of a point 20 cm from the center, and flo’s four arrows hit within 1 cm of the center. the contest judge says that one of the archers is precise but not accurate, another archer is accurate but not precise, and the third archer is both accurate and precise. which description applies to which archer? explain

Answers: 2

continue

Physics, 21.06.2019 22:30, IDespretlyneedhelp

Solar cell a produces 100 joules of energy, when a light source is shown on it for 3 minutes. solar cell b produces 200 joules of energy when the same light source is shown on it for 5 minutes. which solar cell works better? a) solar cell b, because it produces more energy. b) solar cell b, because it generates more power. c) solar cell a, because it produces energy quicker. d) solar cell a, because it generates a greater wattage. eliminate

Answers: 2

continue

Physics, 22.06.2019 02:50, lilybear1700

Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)