a shot putter accelerates a 7.3kg shot from rest to 14m/s in 1.5r seconds. what average power was developed?

During physical science, ms. greene challenged her students to produce an energy transformation. james and jill wrapped a 4-inch nail with a coil of fifty turns of wire. they connected one end of the coil to one terminal of a knife switch. they connected the other terminal of the knife switch to the battery. finally, they connected the end of the coil to the other terminal of the battery. james held the tip of a 1-inch nail near the flat end of the 4-inch nail. jill closed the knife switch quickly and then opened it. the 1-inch nail was pulled toward the 4-inch nail. what is the best explanation of why the nail moved? a) electrical energy was converted to mechanical energy in the 1-inch nail. b) the 4-inch nail became an electromagnet and the magnetic force attracted the 1-inch nail. c) the electric current in the 4-inch nail was converted to mechanical energy in the 1-inch nail. d) the 4-inch nail had a positive charge and the 1-inch nail had a negative charge. opposites attracted.

Need asap ! what is the relationship between atmospheric pressure and the density of gas particles in an area of increasing pressure? (2 points) as air pressure in an area increases, the density of the gas particles in that area decreases. as air pressure in an area increases, the density of the gas particles in that area increases. as air pressure in an area increases, the density of the gas particles in that area remains constant. as air pressure in an area increases, the density of the gas particles in that area increases and decreases in an alternating pattern. 3. which of the following correctly describes a way in which earth's atmosphere interacts with the geosphere? (2 points) it contains gases that living organisms breathe. it contains gases that trap incoming solar radiation. it provides a medium for cycles that provide nutrients to living organisms. it provides a medium for water to move between earth's surface and the air. 4. which of the following is considered a drawback to using wind energy as a source of power? (2 points) wind energy is nonrenewable. wind energy produces large amounts of air pollution. 5. a meteorologist predicts that the weather in a region will soon change from clear skies to probable thunderstorms. prior to making this prediction, what did the meteorologist most likely observe on a barometer? (2 points) the barometer fell slightly. the barometer fell substantially. the barometer rose slightly. the barometer rose substantially. 6. which of the following do meteorologists not typically use weather balloons to record? (2 points) atmospheric pressure cloud types humidity temperature 7. during which step in the can crush lab did water vapor force air from the can? (2 points) the can was filled nearly to the top with water. the can was placed on the hot stove top burner for several minutes. the can was removed from the hot stove top burner. the can was placed upside-down in the water-filled pan.

Total solidification times of three casting geometries are to be compared: a sphere, a cylinder, in which the length-to-diameter ration - 1.0, and a cube. volume = 1000 cm^3 for all three shhapes, and the same casting alloy is used. a) determine the solidification times of each geometry b) based on the results of part (a), which geometric element would make the best riser? c) if the mold constant = 3.5 min/cm^2 in chvorinov's rule, compute the total solidification time for each casting.