Physics, 19.06.2020 12:57 yofavvlele

Write down four reasons why plastic is put around electrical wires?

Plz help me

Answers: 3

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 08:20, jrjordans13ox06qs

At an oceanside nuclear power plant, seawater is used as part of the cooling system. this raises the temperature of the water that is discharged back into the ocean. the amount that the water temperature is raised has a uniform distribution over the interval from 10° to 25° c. what is the standard deviation of the temperature increase?

Answers: 1

continue

Physics, 22.06.2019 17:10, hollycoleman13

Both independent and dependent clauses

Answers: 1

continue

Physics, 22.06.2019 19:30, cakey3501

The nuclear potential that binds protons and neutrons in the nucleus of an atom is often approximated by a square well. imagine a proton conned in an innite square well of length 105 nm, a typical nuclear diameter. calculate the wavelength and energy associated with the photon that is emitted when the proton undergoes a transition from the rst excited state (n 2) to the ground state (n 1). in what region of the electromagnetic spectrum does this wavelength belong?

Answers: 1

continue

Physics, 23.06.2019 07:00, Fireburntbudder

Your physics assignment is to figure out a way to use electricity to launch a small 6.0-cm-long plastic drink stirrer. you decide that you'll charge the little plastic rod by rubbing it with fur, then hold it near a long, charged wire, as shown in figure p23.56 . when you let go, the electric force of the wire on the plastic rod will shoot it away. suppose you can uniformly charge the plastic stirrer to 10 nc and that the linear charge density of the long wire is 1.0 x10-7 c/m. what is the net electric force on the plastic stirrer if the end closest to the wire is 2.0 cm away?

Answers: 1

continue

You know the right answer?

Write down four reasons why plastic is put around electrical wires?

Plz help me...