subject
Physics, 19.05.2020 12:59 Derrionna

Which of the following results was evidence that the proton was part of an atom's nucleus?
A). The alpha particles passed straight through the foil.
B). A few hits of alpha particles were noticed on the sides of the film.
C). The alpha particles stayed stuck to the gold foil.
D). The alpha particles shot at the gold foil straight back off the foil and stuck the front side of the film.

ansver
Answers: 2

Other questions on the subject: Physics

image
Physics, 21.06.2019 22:00, greenclonetroop6q2tg
Arock collection comes from which part of earth?
Answers: 1
image
Physics, 22.06.2019 00:40, naomicervero
The rigid beam is supported by the three suspender bars. bars ab and ef are made of aluminum and bar cd is made of steel. if each bar has a cross-sectional area of 450 mm2, determine the maximum value of p if the allowable stress is (σallow)st = 200 mpa for the steel and ( σallow)al = 150 mpa for the aluminum. est = 200 gpa and eal = 70 gpa.
Answers: 1
image
Physics, 22.06.2019 07:20, MannyBanko1350
If the ama of the inclined plane below is 2, calculate the ima and efficiency. ima = efficiency =
Answers: 1
image
Physics, 23.06.2019 02:10, Nathaliasmiles
Find the steady-state temperature at the center of the plate = /2, = /2) for sums of w from n=1 to n=19 (only odd values). find the value of n for which the change in /2, /2) is less than 1% from the value at the previous n. at this point, we consider the solution converged. does the value of the temperature at the center seem reasonable? in this part, the values of x and y are constant scalar values. you should produce a plot of the value of n on the horizontal and the estimate of the temperature at the center of the plate on the vertical. b. using the value of n (or larger) that resulted in convergence in part (a), create a contourf plot of the temperature distribution across the entire plate. use enough spatial subdivisions to create a useful plot. comment on the results. hint: you need to determine what “x” and “y” values to use to make your t matrix. i recommend using a different number of x and y values. use enough x and y values so that the plot is “smooth”.
Answers: 1
You know the right answer?
Which of the following results was evidence that the proton was part of an atom's nucleus?
A)....

Questions in other subjects:

Konu
Biology, 24.02.2021 06:00
Konu
Mathematics, 24.02.2021 06:00