subject
Physics, 25.04.2020 05:02 katherinemoreno353

A sling is used to give a stone an initial velocity of 20 at an angle of 30 above the horizontal. The stone travels through the air and lands a horizontal distance of 32m from where it was released. If the stone returns to the same height from which it was thrown, which of the following claims best describes the motion of the air through the stone's trajectory? There must be a horizontal wind in the direction of the stone's motion, because ignoring air resistance when alculating the horizontal range would yield a value less than 32m There must be a horizontal wind opposite the direction of the stone's motion, because ignoring air resistance when calculating the horizontal range would yield a value less than 32m. (C) There is no horizontal wind, because ignoring air resistance when calculating the horizontal range would yield a value equal to 32m. There must be a horizontal wind in the direction of the stone's motion, because ignoring air resistance when calculating the horizontal range would yield a value greater than 32m. There must be a horizontal wind opposite the direction of the stone's motion, because ignoring air resistance when calculating the horizontal range would yield a value greater than 32m

ansver
Answers: 1

Other questions on the subject: Physics

image
Physics, 22.06.2019 01:30, chloe1107
Which explanation describes the forces involved for a person to walk down the sidewalk? a. the person's feet push backward on the sidewalk; the sidewalk pushes backward on the person. b. the person's feet push forward on the sidewalk; the sidewalk does not push on the person. c. the person's feet push backward on the sidewalk; the sidewalk pushes forward on the person. d. the person's feet push forward on the sidewalk; the sidewalk pushes forward on the person.
Answers: 1
image
Physics, 22.06.2019 08:30, lovebunfan
What is the primary force that suspension bridges use cables to hold their spans up? a. tension force b. resistance force c. normal force d. elastic force e. applied force
Answers: 3
image
Physics, 22.06.2019 08:40, kayleewoodard
Apulley system is used to lift a 2,000 newton engine up a distance of 3 meters. the operator must apply a force of 250 newtons to the chain of the pulley system to lift the motor. to lift the engine 3 meters, the operator must pull a total of 30 meters of chain through the pulley system. what is the value of di?
Answers: 1
image
Physics, 22.06.2019 12:00, angelamirga332
Asolid round steel rod 6.25 mm in diameter and 375 mm long is rigidly bonded to the end of solid square brass rod 25 mm on a side and 300 mm long. the geometric axes of the bare are along the same line. an axial tensile force of 5.4 kn is applied at the extreme ends of the assembly. for steel e = 200 gpa and for brass e = 90 gpa. determine the total elongation for the assembly.
Answers: 1
You know the right answer?
A sling is used to give a stone an initial velocity of 20 at an angle of 30 above the horizontal. Th...

Questions in other subjects: