Physics, 22.04.2020 03:01 corncob155
A high-speed flywheel in a motor is spinning at 450 rpm (revolutions per minute) when a power failure suddenly occurs. The flywheel has mass 45.0 kg and diameter 74.0 cm . The power is off for 25.0 s and during this time the flywheel slows due to friction in its axle bearings. During the time the power is off, the flywheel makes 180 complete revolutions. A. At what rate is the flywheel spinning when the power comes back on? (rad/s)B. How long after the beginning of the power failure would it have taken the flywheel to stop if the power had not come back on? (s)C. How many revolutions would the wheel have made during this time?
Answers: 3
Other questions on the subject: Physics
Physics, 22.06.2019 09:30, sdolina5
This is important. 1. which of the following is an si base unit for measuring length? (2 points) inch gram meter mole 2. which of the following units for distance is an si unit? (2 points) centimeter foot inch yard 3. which of the following tools should a scientist use to measure an object in meters? (2 points) electronic balance pan balance tape measure thermometer
Answers: 2
Physics, 22.06.2019 10:50, afonseca73
Asheet of steel 1.5 mm thick has nitrogen atmospheres on both sides at 1200oc and is permitted to achieve a steady-state diffusion condition. the diffusion coefficient for nitrogen in steel at this temperature is 6 x 10- 11 m2 /s, and the diffusion flux is found to be 1.2 x 10-7 kg/m2 -s. also, it is known that the concentration of nitrogen in the steel at the high-pressure surface is 4 kg/m3 . how far into the sheet from this high-pressure side will the concentration be 2.0 kg/m3 ? assume a linear concentration profile.
Answers: 3
Physics, 22.06.2019 11:00, bumpydumper
The dot diagram represents the motion of the motorcycle as it moves from left to right
Answers: 3
You know the right answer?
A high-speed flywheel in a motor is spinning at 450 rpm (revolutions per minute) when a power failur...
Questions in other subjects:
Chemistry, 20.09.2019 01:00
