Physics, 21.04.2020 18:55 MarishaTucker

During the experiment, you adjusted the length of the rheostat LL6 so that 1 glow flowed through bulb H. Now that we have seen that the (conduction) current measured by a DMM corresponds to the same physical concept as ‘glow’, it makes sense to ask "what current goes through bulb H when 1 glow goes through bulb H?" The consensus in the past has been about 30 mA but you might have been using a slightly larger or smaller current. Remember that you assumed that the bulbs in circuit 7 were identical. If the resistance of rheostat LL6 has been adjusted so that 30 mA flows through bulb H then what current flows through bulb B? What current flows through bulb C?

Answers: 1

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 07:30, AnaiyaKirksey8

This is the substance(s) formed in a chemical reaction.

Answers: 1

continue

Physics, 22.06.2019 09:00, bendmads04

In a heat engine if 1000 j of heat enters the system the piston does 500 j of work, what is the final internal energy of the system if the initial energy was 2000 j? 1. write the equation 2.list out your known variables 3.plug the numbers into the equations 4.solve 5.write your solution statement that includes initial energy and final

Answers: 1

continue

Physics, 22.06.2019 09:30, sdolina5

This is important. 1. which of the following is an si base unit for measuring length? (2 points) inch gram meter mole 2. which of the following units for distance is an si unit? (2 points) centimeter foot inch yard 3. which of the following tools should a scientist use to measure an object in meters? (2 points) electronic balance pan balance tape measure thermometer

Answers: 2

continue

Physics, 22.06.2019 10:20, brandon1888

Asmall object with mass 0.200 kg swings back and forth on the lower end of a light rope that is 3.00 m long. the upper end of the rope is attached to the ceiling. as the object swings through its lowest position, where the rope is vertical, the speed of the object is 5.80 m/s. at this point in the motion, what is the tension in the rope? (use g = 9.80 m/s2.)

Answers: 2

continue

You know the right answer?

During the experiment, you adjusted the length of the rheostat LL6 so that 1 glow flowed through bul...