subject
Physics, 21.04.2020 15:29 caggh345

Technician A says that in any type of fluid coupling not equipped with a mechanical lock-up some slippage exists resulting in a difference between input and output speeds. Technician B says that in torque converter coupling phase impeller and turbine rpms match. Who is correct

ansver
Answers: 3

Other questions on the subject: Physics

image
Physics, 22.06.2019 01:00, anna4060
First, launch the video below. you will be asked to use your knowledge of physics to predict the outcome of an experiment. then, close the video window and answer the question at right. you can watch the video again at any point. part a as in the video, we apply a charge +q to the half-shell that carries the electroscope. this time, we also apply a charge –q to the other half-shell. when we bring the two halves together, we observe that the electroscope discharges, just as in the video. what does the electroscope needle do when you separate the two half-shells again? view available hint(s) as in the video, we apply a charge + to the half-shell that carries the electroscope. this time, we also apply a charge – to the other half-shell. when we bring the two halves together, we observe that the electroscope discharges, just as in the video. what does the electroscope needle do when you separate the two half-shells again? it deflects more than it did at the end of the video. it deflects the same amount as at end of the video. it does not deflect at all. it deflects less than it did at the end of the video. submit
Answers: 2
image
Physics, 22.06.2019 09:00, lexis1446
Infrared rays have a shorter wavelength than question 11 options: x-rays. ultraviolet rays. radio waves. gamma rays.
Answers: 1
image
Physics, 22.06.2019 14:10, nikki4367
Amachinist turns the power on to a grinding wheel, at rest, at time t = 0 s. the wheel accelerates uniformly for 10 s and reaches the operating angular velocity of 96 rad/s. the wheel is run at that angular velocity for 40 s and then power is shut off. the wheel slows down uniformly at 1.5 rad/s2 until the wheel stops. in this situation, the time interval of deceleration is closest to:
Answers: 3
image
Physics, 22.06.2019 17:50, arunamvr
Which of the following best describes internal energy? a. the difference between the kinetic and potential energies of the particles in a system b. the sum of the kinetic and potential energies of the particles in a system c. the sum of the kinetic and thermal energies of the particles in a system d. the difference between the kinetic and thermal energies of the particles in a system
Answers: 2
You know the right answer?
Technician A says that in any type of fluid coupling not equipped with a mechanical lock-up some sli...

Questions in other subjects:

Konu
Health, 26.07.2019 07:30