Physics, 17.04.2020 18:08 martinbricein10
A good rule of thumb is to design the horizontal stabilizer so that its area is about 1/6 to 1/8 of the area of the wing. If the area of the wing is 110.25 cm^2, what should the area of the horizontal stabilizer be?
a. 20 cm^2
b. 10 cm^2
c. 30 cm^2
d. 15 cm^2
Answers: 3
Physics, 22.06.2019 16:40, dylan6981
The astronauts on the space shuttle flights experienced an acceleration of 29 m/s2 (about 3 "g's") during lift-off. what upward force must the astronaut's seat apply to the astronaut in order to cause this acceleration? assume the astronaut's mass is 70 kg, and compute this force when the acceleration is near the earth's surface so their weight equals latex: mg m g .
Answers: 3
Physics, 22.06.2019 21:30, missy9225
A1500 w electric heater is plugged into the outlet of a 120 v circuit that has a 20 a circuit breaker. you plug an electric hair dryer into the same outlet. the hair dryer has power settings of 600 w, 900 w , 1200 w, and 1500 w. you start with the hair dryer on the 600 w setting and increase the power setting until the circuit breaker trips. under what setting does the circuit breaker trip.
Answers: 2
Physics, 23.06.2019 00:00, polarbear3787
Which one of the following represents the reduced forms of the two major electron carriers? nadh and fadh2 nad+ and fadh2 nad+ and fad nadh and fad
Answers: 3
A good rule of thumb is to design the horizontal stabilizer so that its area is about 1/6 to 1/8 of...
Mathematics, 10.01.2020 00:31
Health, 10.01.2020 00:31
Mathematics, 10.01.2020 00:31
Health, 10.01.2020 00:31