Answers: 3
Physics, 23.06.2019 00:30, GachaSkylarUwU
Part of a control linkage for an airplane consists of a rigid member cb and a flexible cable ab. if a force is applied to the end b of the member and causes it to rotate by θ = 0.5°, determine the normal strain in the cable. originally the cable is unstretched.
Answers: 2
Physics, 23.06.2019 02:10, Nathaliasmiles
Find the steady-state temperature at the center of the plate = /2, = /2) for sums of w from n=1 to n=19 (only odd values). find the value of n for which the change in /2, /2) is less than 1% from the value at the previous n. at this point, we consider the solution converged. does the value of the temperature at the center seem reasonable? in this part, the values of x and y are constant scalar values. you should produce a plot of the value of n on the horizontal and the estimate of the temperature at the center of the plate on the vertical. b. using the value of n (or larger) that resulted in convergence in part (a), create a contourf plot of the temperature distribution across the entire plate. use enough spatial subdivisions to create a useful plot. comment on the results. hint: you need to determine what “x” and “y” values to use to make your t matrix. i recommend using a different number of x and y values. use enough x and y values so that the plot is “smooth”.
Answers: 1
Physics, 23.06.2019 13:30, ladeshak5981
The goal of this experiment was to answer the question, "how does diffraction occur? " suppose you formulated this alternate hypothesis: if the gap width is increased while keeping wavelength constant, then the observed diffraction will decrease because the less the ratio between wavelength and gap width is, the smaller the observed diffraction angle will be. to test this hypothesis, you would change the gap widthdiffraction anglewavelength and observe the gap widthdiffraction anglewavelength in the system. therefore, the independent variable would be the gap widthdiffraction anglewavelength and the dependent variable would be the gap widthdiffraction anglewavelength.
Answers: 1
Calculate the final velocity of each particle when they reach the negative plate, assuming they both...
Mathematics, 28.09.2021 16:00
Biology, 28.09.2021 16:10
English, 28.09.2021 16:10