Physics, 01.04.2020 03:31 georgehall3027

What are dot diagrams in Physical Science?

Answers: 3

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 12:10, malikbryant2002

Consider a one meter long horizontal pipe with a constant 100 cm^2 cross sectional area. water flows rightward into the pipe at x = 0 with flow velocity 02m/sec at every point within the pipe intake area. at x=1, the rightward flow rate is 0.192 m/sec. assume the water is a conserved quantity in the pipe, so there must be a leak (a sink) somewhere in the pipe. 1. compute net volumetric flow of the source if the system to be in equilibrium. 2. now assume the pipe in the problem has no leaks. compute the net volumetric rate of change for the system.

Answers: 3

continue

Physics, 22.06.2019 13:20, Tess3492

It is reasonable to assume that the bulk modulus of blood is about the same as that of water (2.2 gpa). as one goes deeper and deeper in the ocean, the pressure increases by 10000 pa for every meter below the surface. if a diver goes down 80.0 m in the ocean, by how much does each cubic centimeter of her blood change in volume? give the answer in cubic centimeters (actually one cubic centimeter equals one milliliter).

Answers: 2

continue

Physics, 22.06.2019 17:00, Gabriel134

Two conductors, a and b, are each in the shape of a tetrahedron. but of different sizes. they are charged in the following manner: 1. tetrahedron a is charged from an electrostatic generator to charge q. 2. tetrahedron a is briefly touched to tetrahedron b. 3. steps 1 and 2 are repeated until the charge on tetrahedron b reaches a maximum value. if the charge on tetrahedron b was q/4 after the first time it touched tetrahedron a. what is the final charge qbmax on tetrahedron b?

Answers: 2

continue

Physics, 23.06.2019 03:10, stotherow5

You have been hired to design a spring-launched roller coaster thatwill carry two passengers per car. the car goes up a 10-m highhill, then descends 15m to the track's lowest point. you'vedetermined that the spring can be compressed a maximum o 2.0m andthat a loaded car will have a maximum mass of 400kg. for safetyreasons, the spring constant should be 10% larger than the minimumneeded for the car to just make it over the top. a) what spring constant (k) should you specify ? b) what is the maximum speed of a 350 kg car if the spring iscompressed the full amount.