Physics, 20.10.2019 11:20 Buddy01

Consider an object sliding at constant velocity along a frictionless surface. which of the following best describes the forces on the object?

there is a net force at right angles to the direction of motion

there is a net force in the direction of motion, that is independent of the object’s velocity

there is a net force in the direction of motion, that depends on the object’s velocity

there is zero net force on the object

Answers: 3

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 04:30, loloi83

Acrow drops a 0.11kg clam onto a rocky beach from a height of 9.8m. what is the kinetic energy of the clam when it is 5.0m above the ground? what is its speed at that point?

Answers: 1

continue

Physics, 22.06.2019 05:20, cwsmith8026

Very large accelerations can injure the body, especially if they last for a considerable length of time. one model used to gauge the likelihood of injury is the severity index ( ), defined as =/ . in the expression, is the duration of the accleration, but is not equal to the acceleration. rather, is a dimensionless constant that = the number of multiples of that the acceleration is equal to. in one set of studies of rear-end collisions, a person's velocity increases by 13.7 km/h with an acceleration of 36.0 m/s2 . let the + direction point in the direction the car is traveling. what is the severity index for the collision?

Answers: 1

continue

Physics, 22.06.2019 16:50, Walkman2092

Calculate the first and second velocities of the car with four washers attached to the pulley, using the formulas v1 = 0.25 m / t1 , and v2 = 0.25 m / (t2 – t1) where t1 and t2 are the average times the car took to reach the 0.25 and the 0.50 meter marks. record these velocities, to two decimal places, in table e.

Answers: 2

continue

Physics, 22.06.2019 19:40, mcmccann4317

It may seem strange that the selected velocity does not depend on either the mass or the charge of the particle. (for example, would the velocity of a neutral particle be selected by passage through this device? ) the explanation of this is that the mass and the charge control the resolution of the device--particles with the wrong velocity will be accelerated away from the straight line and will not pass through the exit slit. if the acceleration depends strongly on the velocity, then particles with just slightly wrong velocities will feel a substantial transverse acceleration and will not exit the selector. because the acc

Answers: 1

continue

You know the right answer?

Consider an object sliding at constant velocity along a frictionless surface. which of the following...