Physics, 15.03.2020 00:55 victoriamscott460

Change velocity from 1 km second to 1.8 km second in .03 seconds what is the acceleration

Answers: 2

Show answers

Other questions on the subject: Physics

Physics, 21.06.2019 19:30, kayleegeise

Identical marbles are released from the same height on each of the following four frictionless ramps . compare the speed of the marbles at the end of each ramp. explain your reasoning

Answers: 3

continue

Physics, 22.06.2019 00:30, Waakkaa

Glass is transparent to visibile light under normal conditions; however, at extremely high intensities, glass will absorb most of the light incident upon it. this works through a process known as multiphoton absorption. in this process, several photons are absorbed at the same time. if very intense light whose photons carry 2ev of energy is shined onto a material with a band gap of 4ev, that light can be absorbed through two-photon absorption, because two photons have the right amount of energy to bridge the band gap. what is the minimum number of photons of 800-nm light that are needed to equal or exceed the band gap of fused silica glass

Answers: 1

continue

Physics, 22.06.2019 02:00, Kyliehayden05

Which statements about tornadoes are true? check all that apply. (a) about 12,000 tornadoes hit the united states every year. (b) a tornado looks like a funnel. (c) tornadoes are deadly atmospheric storms that cause millions in damages each year. (d) tornadoes can reach wind speeds of more than 300 miles per hour. (e) kansas is the state with the most tornadoes. (f) you will always notice a funnel before a tornado strikes.

Answers: 2

continue

Physics, 22.06.2019 02:50, lilybear1700

Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)

Answers: 3

continue

You know the right answer?

Change velocity from 1 km second to 1.8 km second in .03 seconds what is the acceleration...