subject
Physics, 07.03.2020 05:28 ejsteel2

As a new electrical technician, you are designing a large solenoid to produce a uniform 0.160 {\rm T} magnetic field near the center of the solenoid. You have enough wire for 4200 circular turns. This solenoid must have a length of 1.25 {\rm m} and a diameter of 19.0 {\rm cm}.What current will you need to produce the necessary field?

ansver
Answers: 2

Other questions on the subject: Physics

image
Physics, 21.06.2019 18:30, samieskyy290
Apassenger walks toward the rear of a moving train. describe her motion as seen from a reference point on the train. then describe it from a reference point on the ground
Answers: 2
image
Physics, 22.06.2019 18:50, rurbanok12
8.29 two streams containing pyridine and acetic acid at 25°c are mixed and fed into a heat exchanger. due to the heat-of-mixing effect, it is desired to reduce the temperature after mixing to 25°c using a stream of chilled ethylene glycol as indicated in the diagram. calculate the mass flow rate of ethylene glycol needed. the heat capacity of ethylene glycol at these conditions is approximately 2.8 kj/(kg k), and the enthalpy change of mixing (δmixh) is given below.
Answers: 3
image
Physics, 23.06.2019 01:00, airbenderjermai
The bubbles in a carbonated soft drink are produced when carbonic acid decomposes to form carbon dioxide and water. in a closed system, this equilibrium exists as why does a carbonated soft drink lose carbonation when the container is left open? a. water evaporates, which favors the formation of h2co3. b. pressure decreases, which favors the formation of h2co3. c. the open container warms up, which causes more gas to escape. d. co2is removed, which favors the formation of h2co3.
Answers: 2
image
Physics, 23.06.2019 02:30, roseemariehunter12
Ball bearings are made by letting spherical drops of molten metal fall inside a talll tower-called a shot tower- and solidify as they fall. a-if a bearing needs 4.0 s to solidify enough for impact, how high must the tower be? b- what is the bearing's impact velocity?
Answers: 3
You know the right answer?
As a new electrical technician, you are designing a large solenoid to produce a uniform 0.160 {\rm T...

Questions in other subjects: