subject
Physics, 05.03.2020 19:45 gabrielledismang

Technician A says that most TSBs involve a specific stored DTC. Technician B says that the ECT and IAT reading should be close to the same temperature after the vehicle sits for several hours. Which technician is correct?

A) Technician A only

B) Technician B only

C) Both technicians

D) Neither technician

ansver
Answers: 2

Other questions on the subject: Physics

image
Physics, 22.06.2019 00:20, glogaming16
In the derivation of rrkm theory, a factor of 1/2 is introduced when equalizing the rates of formation and decomposition of activated complex as keal-hr) = ko this is clearly against the assumption of transition state theory that states all the activated complex in the transition state iss going to the product. find the reason why this factor is introduced here.
Answers: 2
image
Physics, 22.06.2019 11:20, cjd1214812148
The ultracentrifuge is an important tool for separating and analyzing proteins. because of the enormous centripetal accelerations, the centrifuge must be carefully balanced, with each sample matched by a sample of identical mass on the opposite side. any difference in the masses of opposing samples creates a net force on the shaft of the rotor, potentially leading to a catastrophic failure of the apparatus. suppose a scientist makes a slight error in sample preparation and one sample has a mass 10 mg larger than the opposing sample. if the samples are 12 cm from the axis of the rotor and the ultracentrifuge spins at 70,000 rpm, what is the magnitude of the net force on the rotor due to the unbalanced samples? ( be thorough on your answer)
Answers: 3
image
Physics, 22.06.2019 15:30, anahitrejo1
1kg of water needs to recieve 4200j of energy to go from 90 degrees to 91 degrees. what is the specific heat capacity of water? what are the units?
Answers: 1
image
Physics, 23.06.2019 00:40, bravomichelle75
Asteel tube (k=50 w/mk) of inner and outer diameter di = 20mm and do=26mm, respectively, is used to transfer heat from hot gases flowing over the tube (h-hot = 200w/m2k) to cold water flowing through the tube (h-cold = 8000 w/m2k). what is the cold-side overall heat transfer coefficient uc? to enhance heat transfer 16 straight fins of rectangular profile are installed longitudinally along the outer surface of the tube. the fins are equally spaced around the circumference of the tube, each having a thickness of 2mm and a length of 15mm. what is the corresponding overall heat transfer coefficient uc? *solve for uc in both cases*
Answers: 1
You know the right answer?
Technician A says that most TSBs involve a specific stored DTC. Technician B says that the ECT and I...

Questions in other subjects:

Konu
Geography, 04.12.2020 01:00