When thinking about an electric circuit, you usually focus not on the motion of individual charges, but rather on the continuous current (charge per unit time) flowing through the circuit. Thus, rather than considering the work done on a particular charge, it is useful to compute the work done per unit time on the charge flowing through the circuit, or in other words, the power. Find the electrical power PPP delivered to the resistor via the work done on the individual charges passing through it. (Again, this power ultimately appears in the form of heat). Express PPP in terms of quantities given in the problem introduction.

Momentum lab this lab uses a phet simulation. navigate to the phet momentum simulation. if you don’t see the image below when you click on the link, then you need to either enable adobe flash (click on the puzzle piece on your screen) or you need to install adobe flash (this is a free program). change the vectors to be momentum vectors only. they are yellow. make the mass of both balls the same. hit play and notice what happens to the momentum vectors before and after the collision. you might want to play the sim multiple times. click on restart or return balls to start over. to see numbers, check the show values box (inside the green box). red’s momentum vector before the collision is green’s momentum vector after the collision. question 1 options: shorter than longer than equal to question 2 (1 point) saved since green bounces off red, this must be an collision. question 2 options: explosion inelastic elastic question 3 (1 point) red transfers of its momentum to green during the collision. question 3 options: little all most none question 4 (4 points) why does red transfer all its momentum to green? back up your answer with information from the simulation. write at least 2 sentences.