subject
Physics, 24.02.2020 23:18 rudolph34

Air containing gasoline vapor is admitted into the cylinder of an internal combustion engine at 1.00 atm pressure and 30 °C. The piston rapidly compresses the gas from 500 cm3 to 50 cm3, a compression ratio of 10. This type of compression is too rapid for heat to be transferred from the gas to the environment, so it can be modeled as an adiabatic compression. (a) What are the final temperature and pressure of the ? (b) Show the compression process on a pV diagram. (c) How much work is done to compress the gas? [air is a mixture of N2 and O2, diatomic gases, so use yair 1.4 L7. as 0]

ansver
Answers: 2

Other questions on the subject: Physics

image
Physics, 21.06.2019 22:50, Bt758
Two horizontal plates with infinite length and width are separated by a distance h in the z direction. the bottom plate is moving at a velocity u. the incompressible fluid trapped between the plates is moving in the positive x-direction with the bottom plate. align gravity with positive z. assume that the flow is fully-developed and laminar. if the systems operates at steady state and the pressure gradient in x-direction can be ignored, do the following: 1. sketch your system 2. identify the coordinate system to be used. 3. show your coordinates and origin point on the sketch. list all your assumptions. 5. apply the continuity equation to your system. nts of navier stokes equations of choice to your system 7. solve the resulting differential equation to obtain the velocity profile within the system make sure to list your boundary conditions. check units of velocity 8. describe the velocity profile you obtain using engineering terminology. sketch that on the same sketch you provided in (1). 9. obtain the equation that describes the volumetric flow rate in the system. check the units.
Answers: 2
image
Physics, 21.06.2019 23:30, jetblackcap
Which of the following statements is true about women and minorities in early psychology? a. in the early 20th century, numerous graduate schools recruited women and minorities to study psychology. b. opportunities in higher education were limited for women and minorities in the early 20th century due to discrimination. c. despite some obstacles, there were numerous employment opportunities for women and minorities. d. women and minorities were often selected to do academic research in an effort to make the field more diverse.
Answers: 3
image
Physics, 22.06.2019 08:00, jhanes1983
Ms. hidalgo opens the door to her classroom. her classroom is 60 degrees and the air outside is 80. predict what will happen using your knowledge of how heat flows.
Answers: 2
image
Physics, 22.06.2019 12:00, angelamirga332
Asolid round steel rod 6.25 mm in diameter and 375 mm long is rigidly bonded to the end of solid square brass rod 25 mm on a side and 300 mm long. the geometric axes of the bare are along the same line. an axial tensile force of 5.4 kn is applied at the extreme ends of the assembly. for steel e = 200 gpa and for brass e = 90 gpa. determine the total elongation for the assembly.
Answers: 1
You know the right answer?
Air containing gasoline vapor is admitted into the cylinder of an internal combustion engine at 1.00...

Questions in other subjects: