How does the total momentum of the docked vehicle and station compare to the momentum of each object before the
docking maneuver?
greater momentum
same momentum
less momentum
( b same momentum ) on ed2020

The total momentum before the docking maneuver is  and after the docking maneuver is

Explanation:

Linear momentum  (generally just called momentum) is defined as mass in motion and is given by the following equation:  

Where  is the mass of the object and  its velocity.

According to the conservation of momentum law:

"If two objects or bodies are in a closed system and both collide, the total momentum of these two objects before the collision  will be the same as the total momentum of these same two objects after the collision ".

This means, that although the momentum of each object may change after the collision, the total momentum of the system does not change.

Now, the docking of a space vehicle with the space station is an inelastic collision, which means both objects remain together after the collision.

Hence, the initial momentum is:

Where:

is the mass of the vehicle

is the velocity of th vehicle

is the mass of the space station

is the velocity of the space station

And the final momentum is:

Where:

is the velocity of the vehicle and space station docked

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

energy can be converted from one form to another, but it cannot be created or destroyed in ordinary chemical or physical means. do not understand what you are asking but hope this