Answers: 2
) and inversely proportional to the square of the distance(R) that separates them:
Other questions on the subject: Physics
Physics, 21.06.2019 17:30, Bladen6579
Abaseball picther can throw a ball at about 90 miles per hour, v = 40 m/s, on solid rock ground. we now put him into space. when he throws the ball, which weighs mb = 0.15 kg moves away from himat the same speed. how long does it take the ball thrown in space to travel the 30 meters to the batter? he weighs mp = 100kg
Answers: 1
Physics, 22.06.2019 20:00, teescub9738
In an old-fashioned amusement park ride, passengers stand inside a 3.0-m-tall, 5.0-m-diameter hollow steel cylinder with their backs against the wall. the cylinder begins to rotate about a vertical axis. then the floor on which the passengers are standing suddenly drops away! if all goes well, the passengers will “stick” to the wall and not slide. clothing has a static coefficient of friction against steel in the range 0.60 to 1.0 and a kinetic coefficient in the range 0.40 to 0.70. part a what is the minimum rotational frequency, in rpm, for which the ride is safe? express your answer using two significant figures. f f = rpm
Answers: 1
Physics, 23.06.2019 06:30, IkarosSakurai
Asquare isothermal chip is of width w=5 mm on a side and is mounted in a substrate such that its side and back surfaces are well insulated; the front surface is exposed to the flow of a coolant at tinf=15 °c. from reliability considerations, the chip temperature must not exceed t=85 °c. if the coolant is air and the corresponding convection coefficient is h=200 w/m2 x k, what is the maximum allowable "power" of the chip? if the coolant is a liquid for which h=3000 w/m2 x k, what is the maximum allowable power of the chip?
Answers: 2
Physics, 23.06.2019 07:00, hockejoh000
Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater. what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?
Answers: 3
You know the right answer?
Two positive point charges Q and 2Q are separated by a distance R. If the charge Q experiences a for...
Questions in other subjects:
Physics, 16.10.2020 17:01
History, 16.10.2020 17:01
Mathematics, 16.10.2020 17:01
Mathematics, 16.10.2020 17:01
