A conical container of radius 10 ft and height 40 ft is filled to a height of 36 ft of a liquid weighing 60.6 lb divided by ft cubed. How much work will it take to pump the contents to the rim? How much work will it take to pump the liquid to a level of 4 ft above the cone's rim?

Explanation:

The centre of mass of a right cone of height, H lies on the axis of symmetry at a distance of H/4 from the base

= 3H/4 from top.

D = 5 + 36/4

= 14 ft from the upper rim

Mass of liquid in the cone = volume × density (ρ)

= ⅓.π.r².h.ρ

= ⅓ × 36 × [10 × (36/40)]² × π × 60.6

= 18505 lbs.

where,

r = radius of the liquid surface.

Workdone required to lift this to the rim

= force * distance

= 18505 * 4.45 × 14

= 1152861.5 N.ft.

B.

4 ft above the rim needs an extra 1152861.5 × 4

= 4611446 N.ft.

Total workdone = 1152861.5 + 4611446

= 5764307.5 J.

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

do you have a formula possibly