Technician a says that a proper u-joint inspection can be done with the driveshaft in place on the vehicle. technician b says that you must remove the driveshaft to properly inspect the u-joints. who is wright?

TECHNICIAN B

Explanation: Drive shaft is an elongated part of the drive system made of steel of a vehicle that transmits the ENGINE TORQUE to the WHEELS of a vehicle. For proper inspection a technician is expected to completely remove the driveshaft to check all its compactment. It is  Cylindrical and usually used for REAR-WHEEL-VEHICLES. Drive shafts are known by different names like propeller shaft,Cardan shaft etc it has different types which range from

One-piece drive shaft ,Two-piece drive shaft  to Slip-in-tube drive shaft .

-first use of geothermal energy occurred more than 10,000 years ago in north america by american paleo-indians

-the first industrial use of geothermal energy began near pisa, italy in late 18th century

-in 1904, italian scientist piero ginori conti invented the first geothermal electric power plant in which steam was used to generate the power

-with the above experiment, the first geothermal plant in usa started in 1922 with a capacity of 250 kilowatts

-however, in 1946 first ground-source geothermal heat pump installed at commonwealth building in portland, oregon

-during the 1960’s, pacific gas and electric began operation of first large scale geothermal power plant in san francisco, producing 11 megawatts

-in 1973, when oil crisis began many countries began looking for renewable energy sources and by 1980’s geothermal heat pumps (ghp) started gaining popularity in order to reduce heating and cooling costs

-as effect of climate change started showing results, governments of various countries joined hands to fight against it, for which kyoto protocol was signed in japan in 1997, laid out emission targets for rich countries and required that they transfer funds and technology to developing countries, 184 countries have ratified it

hope this