subject
Physics, 18.01.2020 02:31 averycipher

Tot which of the following formulas can be used to find the magnitude of the force on a charge moving at an angle
through a magnetic field?
a. f = ged
b. f = qvbsine
c. f = macose
d. f = qvbcose

ansver
Answers: 3

Other questions on the subject: Physics

image
Physics, 21.06.2019 22:00, markyyy53
Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)
Answers: 1
image
Physics, 22.06.2019 04:30, johnkings140
The image shows the positions of a car on a roller coaster track. arrange the cars in order based on their gravitational potential energy. begin with the lowest potential energy and end with the highest.
Answers: 1
image
Physics, 22.06.2019 15:30, 2605098
Ametal ring 4.20 cm in diameter is placed between the north and south poles of large magnets with the plane of its area perpendicular to the magnetic field. these magnets produce an initial uniform field of 1.12 t between them but are gradually pulled apart, causing this field to remain uniform but decrease steadily at 0.240 t/s . (a) what is the magnitude of the electric field induced in the ring? (b) in which direction (clockwise or counterclockwise) does the current flow as viewed by someone on the south pole of the magnet?
Answers: 2
image
Physics, 22.06.2019 15:30, melanieambrosy
To understand the behavior of the electric field at the surface of a conductor, and its relationship to surface charge on the conductor. a conductor is placed in an external electrostatic field. the external field is uniform before the conductor is placed within it. the conductor is completely isolated from any source of current or charge. part a: which of the following describes the electric field inside this conductor? it is in the same direction as the original external field. it is in the opposite direction from that of the original external field. it has a direction determined entirely by the charge on its surface. it is always zero. part b: the charge density inside the conductor is: 0non-zero; but uniformnon-zero; non-uniforminfinite part c: assume that at some point just outside the surface of the conductor, the electric field has magnitude e and is directed toward the surface of the conductor. what is the charge density η on the surface of the conductor at that point? express your answer in terms of e and ϵ0
Answers: 1
You know the right answer?
Tot which of the following formulas can be used to find the magnitude of the force on a charge movin...

Questions in other subjects: