Physics, 21.12.2019 00:31 jaiyaharoldjh

Which part of the manufacturing process involves heating and rolling blocks of steel into flat sheets and bars?
a. forming
b. finishing
c. conditioning
d. separating

Answers: 2

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 08:00, jpsaad00

Tafari worked one summer on a ship that set weather buoys in the ocean. he watched how one of the buoys moved in the water. describe which parts of the wave would cause the buoy to bob up and down. which wave property determined how fast the buoys bobbed in the water? he observed that when the wind blew harder, the ocean waves were larger, and the buoys moved away from the ship. what effect, if any, did the waves have on how far the buoys moved? explain your answer.

Answers: 3

continue

Physics, 22.06.2019 11:00, AnonymousLizard52303

Arowboat passenger uses an oar to push the boat off the dock by exerting a force of 40n for 3.0s. what impulse acts on the boat.

Answers: 1

continue

Physics, 22.06.2019 12:30, lmolder1329

Consider a 1000 w iron whose base plate is made of 0.5 cm thick aluminum alloy 2024-t6 (ρ = 2770 kg/m3 and cp = 875 j/kg°c). the base plate has a surface area of 0.03 m2. initially, the iron is in thermal equilibrium with the ambient air at 22°c. assuming 90% of the heat generated in the resistance wires is transferred to the plate, determine the minimum time needed for the plate temperature to reach 200°c.

Answers: 1

continue

Physics, 22.06.2019 12:30, decemberbooker2505

Brades exam guidelines exam instructions billing & payments & support question 6 of 20 : select the best answer for the question use this illustration to answer the question below. forms & resources al programs 9 ww linics 6. in the circuit shown in the figure above, suppose that the value of r, is 100k, and the value of r2 is 470 kq. at which of the following locations in the circuit would you measure the highest voltage with your meter? rvices 999999 a. between points b and c b. between points a and b c. between points b and e d. between points a and c eredu mark for review (will be highlighted on the review page) mend < < previous question next question

Answers: 1

continue

You know the right answer?

Which part of the manufacturing process involves heating and rolling blocks of steel into flat sheet...