Physics, 19.12.2019 23:31 leakcamille8953

Your car has stalled and you need to push it. you notice as the car gets going that you need less and less force to keep it going. suppose that for the first 15 m your force decreased at a constant rate from 210 n to 45 n. how much work did you do on the car?

Answers: 3

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 00:00, destinycasillas

Name three different units of energy used to measure heat and describe what type of situations each is usually used.

Answers: 2

continue

Physics, 22.06.2019 01:30, chandranewlon

Ablock of mass 1.5 kg slides down an inclined plane that has an angle of 15. if the inclined plane has no friction and the block starts at a height of 3 m, how much kinetic energy does the block have when it reaches the bottom? acceleration due to gravity is g = 9.8 m/s2. a. 6.8 j b. 50.9 j c. 0 j d. 44.1 j

Answers: 1

continue

Physics, 22.06.2019 07:30, anonymous1813

Some material consisting of a collection of microscopic objects is kept at a high temperature. a photon detector capable of detecting photon energies from infrared through ultraviolet observes photons emitted with energies of 0.3 ev, 0.5 ev, 0.8 ev, 2.0ev, 2.5ev, and 2.8ev. these are the only photon energies observed. (a) draw and label a possible energy-level diagram for one of the microscopic objects, which has four bound states. on the diagram, indicate the transitions corresponding to the emitted photons. explain briefly. (b) would a spring–mass model be a good model for these microscopic objects? why or why not? (c) the material is now cooled down to a very low temperature, and the photon detector stops detecting photon emissions. next, a beam of light with a continuous range of energies from infrared through ultraviolet shines on the material, and the photon detector observes the beam of light after it passes through the material. what photon energies in this beam of light are observed to be significantly reduced in intensity (“dark absorption lines”)? explain briefly.

Answers: 3

continue

Physics, 22.06.2019 12:00, marquez8

You have a resistor and a capacitor of unknown values. first, you charge the capacitor and discharge it through the resistor. by monitoring the capacitor voltage on an oscilloscope, you see that the voltage decays to half its initial value in 2.70 miss . you then use the resistor and capacitor to make a low-pass filter. what is the crossover frequency fc?

Answers: 2

continue

You know the right answer?

Your car has stalled and you need to push it. you notice as the car gets going that you need less an...