Physics, 11.12.2019 03:31 ellisc7044

Technician a says that the cam bearings should be installed using a driver and dead blow hammer. technician b says that main bearings and rod bearings should be checked for proper oil clearance by measuring the crankshaft journals and inside diameter of bearings.
which technician is correct?

Answers: 3

Show answers

Other questions on the subject: Physics

Physics, 21.06.2019 15:30, lazarovalle3598

Which of the following statements are true of solids? a. the particles do not vibrate. b. the particles are in a fixed location. c. they have strong intermolecular forces between the atoms or molecules. d. the particles have less kinetic energy than those of liquids or gases.

Answers: 1

continue

Physics, 22.06.2019 12:00, marquez8

You have a resistor and a capacitor of unknown values. first, you charge the capacitor and discharge it through the resistor. by monitoring the capacitor voltage on an oscilloscope, you see that the voltage decays to half its initial value in 2.70 miss . you then use the resistor and capacitor to make a low-pass filter. what is the crossover frequency fc?

Answers: 2

continue

Physics, 22.06.2019 15:10, maudiejane

An important dimensionless parameter concerned with very high-speed flow is the mach number, defined as v/c, where v is the speed of the object such as an airplane or projectile, and c is the speed of sound in the fluid surrounding the object. for a projectile traveling at 1170 mph through air at 50 ˚f and standard atmospheric pressure, what is the value of the mach number?

Answers: 2

continue

Physics, 22.06.2019 17:30, joejoefofana

Atruck driver is attempting to deliver some furniture. first, he travels 8 km east, and then he turns around and travels 3 km west. finally, he turns again and travels 13 km to his destination. what is the drivers distance

Answers: 3

continue

You know the right answer?

Technician a says that the cam bearings should be installed using a driver and dead blow hammer. tec...