Achip measuring 5 mm 5 mm is placed flush on a flat plate 18 cm from the leading edge. the chip is cooled by air at 17oc flowing with a velocity of 56 m/s. determine the maximum power that can be dissipated in the chip if its surface temperature is not to exceed 63oc. assume no heat loss from the back side of the chip.

First, launch the video below. you will be asked to use your knowledge of physics to predict the outcome of an experiment. then, close the video window and answer the question at right. you can watch the video again at any point. part a as in the video, we apply a charge +q to the half-shell that carries the electroscope. this time, we also apply a charge –q to the other half-shell. when we bring the two halves together, we observe that the electroscope discharges, just as in the video. what does the electroscope needle do when you separate the two half-shells again? view available hint(s) as in the video, we apply a charge + to the half-shell that carries the electroscope. this time, we also apply a charge – to the other half-shell. when we bring the two halves together, we observe that the electroscope discharges, just as in the video. what does the electroscope needle do when you separate the two half-shells again? it deflects more than it did at the end of the video. it deflects the same amount as at end of the video. it does not deflect at all. it deflects less than it did at the end of the video. submit

1kg of water needs to recieve 4200j of energy to go from 90 degrees to 91 degrees. what is the specific heat capacity of water? what are the units?

Astone is thrown with a speed v0 and returns to earth, as the drawing shows. ignore friction and air resistance, and consider the initial and final locations of the stone. which one of the following correctly describes the change δpe in the gravitational potential energy and the change δke in the kinetic energy of the stone as it moves from its initial to its final location? options a.δpe = 0 j and δke = 0 j b.δpe is positive and δke is negative c.δpe = 0 j and δke is positive d.δpe is negative and δke is positive e.δpe = 0 j and δke is negative