subject
Physics, 03.12.2019 20:31 mikewalton566

Abritle material has the properties sut = 30 kpsi and suc = 90 kpsi. using the coulomb mohr and modified mohr theories , determine the factor or safety for the following states of plane stresses.

a) σx = 25 kpsi σy =15 kpsi
b) σx = 15 kpsi σy = - 15 kpsi
c) σx = 20kpsi τxy= -10 kpsi
d) σx = - 15 kpsi σy =10 kpsi τxy= -15 kpsi
e) σx = - 20 kpsi σy =- 20 kpsi τxy= -15 kpsi

ansver
Answers: 1

Other questions on the subject: Physics

image
Physics, 22.06.2019 02:30, jendun123ovrxij
The particle in a two-dimensional well is a useful model for the motion of electrons around the indole ring (3), the conjugated cycle found in the side chain of tryptophan. we may regard indole as a rectangle with sides of length 280 pm and 450 pm, with 10 electrons in the conjugated p system. as in case study 9.1, we assume that in the ground state of the molecule each quantized level is occupied by two electrons. (a) calculate the energy of an electron in the highest occupied level. (b) calculate the frequency of radiation that can induce a transition between the highest occupied and lowest unoccupied levels. 9.27 electrons around the porphine ring (4), the conjugated macrocycle that forms the structural basis of the heme group and the chlorophylls. we may treat the group as a circular ring of radius 440 pm, with 20 electrons in the conjugated system moving along the perimeter of the ring. as in exercise 9.26, assume that in the ground state of the molecule quantized each level is occupied by two electrons. (a) calculate the energy and angular momentum of an electron in the highest occupied level. (b) calculate the frequency of radiation that can induce a transition between the highest occupied and lowest unoccupied levels.
Answers: 1
image
Physics, 22.06.2019 12:30, decemberbooker2505
Brades exam guidelines exam instructions billing & payments & support question 6 of 20 : select the best answer for the question use this illustration to answer the question below. forms & resources al programs 9 ww linics 6. in the circuit shown in the figure above, suppose that the value of r, is 100k, and the value of r2 is 470 kq. at which of the following locations in the circuit would you measure the highest voltage with your meter? rvices 999999 a. between points b and c b. between points a and b c. between points b and e d. between points a and c eredu mark for review (will be highlighted on the review page) mend < < previous question next question
Answers: 1
image
Physics, 22.06.2019 16:00, elopezhilario4389
Apersons beliefs and general outlook, which act like filters on the information they receive are called ?
Answers: 1
image
Physics, 22.06.2019 18:00, Messidapro2687
Find the mass by adding the numbers from the three sliders
Answers: 1
You know the right answer?
Abritle material has the properties sut = 30 kpsi and suc = 90 kpsi. using the coulomb mohr and modi...

Questions in other subjects:

Konu
Mathematics, 20.04.2021 23:10
Konu
Mathematics, 20.04.2021 23:10