A780g, 50-cm-long metal rod is free to rotate about a frictionless axle at one end. while at rest, the rod is given a short but sharp 1000n hammer blow at the center of the rod, aimed in a direction that causes the rod to rotate on the axle. the blow lasts a mere 2.5ms.
what is the rod's angular velocity immediately after the blow? the book gives the answer 8.0rad/s
Answers: 1
Other questions on the subject: Physics
Physics, 22.06.2019 11:00, chaycebell6662
A2.00-m long piano wire with a mass per unit length of 12.0 g/m is under a tension of 8.00 kn. what is the frequency of the fundamental mode of vibration of this wire?
Answers: 3
Physics, 22.06.2019 12:00, marquez8
You have a resistor and a capacitor of unknown values. first, you charge the capacitor and discharge it through the resistor. by monitoring the capacitor voltage on an oscilloscope, you see that the voltage decays to half its initial value in 2.70 miss . you then use the resistor and capacitor to make a low-pass filter. what is the crossover frequency fc?
Answers: 2
Physics, 22.06.2019 12:30, morgan3346
Write a full page that sumerizes thermodynamics it’s from the website visionlearnig
Answers: 1
You know the right answer?
A780g, 50-cm-long metal rod is free to rotate about a frictionless axle at one end. while at rest, t...
Questions in other subjects:
Geography, 11.10.2019 21:30
Spanish, 11.10.2019 21:30
Mathematics, 11.10.2019 21:30
Mathematics, 11.10.2019 21:30
Biology, 11.10.2019 21:30
