Physics, 28.11.2019 03:31 micahwilkerson9495

Gwhat are some possible reasons for difference between your measured and calculated values? (select all that apply.) the circuit elements' values differ slightly from their marked values. the calculation ignored the resistance of the wires. the pasco interface did not supply exactly 5.0 v for the maximum voltage. which of the following could occur if an inductor were added to the circuit? the current would increase. the current would decrease. either could occur depending on the inductance added.

Answers: 2

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 22:20, bryanmcmillianjr

Which symbol in the first law of thermodynamics represents the sum of the chemical and thermal energy stored in atoms and molecules? a. q b. w c. v d. u

Answers: 3

continue

Physics, 23.06.2019 02:30, monkemily1

An airplane is flying with a velocity of 240 m/s at an angle of 30.0∘ with the horizontal, as the drawing shows. when the altitude of the plane is 2.4km, a flare is released from the plane. the flare hits the target on the ground. what is the angle θ?

Answers: 3

continue

Physics, 23.06.2019 03:30, jescanarias22

Which statement is true? a) the work done to lift an object 6 meters is greater than the gravitational potential energy it gains. b) the work required to push an object is less than the work required to pull an object the same distance. c) the work required to raise an object to a height is equal to the gravitational potential energy the object gains. d) the work done against gravity to lift an object straight up is greater than the work required to roll it up a ramp.

Answers: 1

continue

Physics, 23.06.2019 03:50, kiylabeasty7302

Asimple electrochemical cell contains two electrodes? t or f

Answers: 2

continue

You know the right answer?

Gwhat are some possible reasons for difference between your measured and calculated values? (select...