subject
Physics, 25.11.2019 20:31 itaheart101

Water from a reservoir passes over a dam through a turbine and discharges from a 70-cm id pipe at a point 55 m below the reservoir surface. the turbine delivers 0.80 mw. calculate the required flow rate of water in m3 /min if friction is neglected. (see example 7.7-3.) if friction were included, would a higher or lower flow rate be required? (note: the equation you will solve in this problem has multiple roots. find a solution less than 2 m3/s.)

ansver
Answers: 3

Other questions on the subject: Physics

image
Physics, 22.06.2019 01:30, kaylin28
Astone is dropped with no initial velocity from the top of a cliff and hits the ground a time of 3.9 s later. what is the height of the cliff, in units of meters? you may assume that air resistance is negligible. give the answer as a positive number question 15 a figure skater is rotating at a rate of 200 revolutions per minute. what is the angular speed, in units of rad/s? 200 o 20.9 12000 o 3.33
Answers: 2
image
Physics, 22.06.2019 16:30, lululoveee586
What happens when you slowly pulled the carboard?
Answers: 2
image
Physics, 22.06.2019 16:50, Walkman2092
Calculate the first and second velocities of the car with four washers attached to the pulley, using the formulas v1 = 0.25 m / t1 , and v2 = 0.25 m / (t2 – t1) where t1 and t2 are the average times the car took to reach the 0.25 and the 0.50 meter marks. record these velocities, to two decimal places, in table e.
Answers: 2
image
Physics, 22.06.2019 18:30, natperal
Aheavy piece of hanging sculpture is suspended by a90-cm-long, 5.0 g steel wire. when the wind blows hard, the wire hums at its fundamental frequency of 80hz. what is the mass of the sculpture?
Answers: 3
You know the right answer?
Water from a reservoir passes over a dam through a turbine and discharges from a 70-cm id pipe at a...

Questions in other subjects:

Konu
Physics, 08.11.2019 10:31