Asmall rubber wheel is used to drive a large pottery wheel, and they are mounted so that their circular edges touch. the small wheel has a radius of 2.0 cm and accelerates at the rate of 7.5 rad/s2, and it is in contact with the pottery wheel (radius 25.0 cm) without slipping.(a) calculate the angular acceleration of the pottery wheel. in rad/s2(b) calculate the time it takes the pottery wheel to reach its required speed of 75 rpm. in seconds

a)  α₂ = 0.6 rad /s² , b) t = 13.1 s

Explanation:

a) This is an angular kinematics exercise. Let's analyze the situation when the two wheels are in contact and without sliding between them the linear speed is the same. Let's write your expressions

Rubber wheel       v₁ = w₁ r₁

Ceramic wheel     v₂ = w₂ r₂

       v₁ = v₂

      w₁ r₁ = w₂ r₂

      w₂ = w₁ r₁ / r₂

We use the angular kinematic equation for the rubber wheel  

      w₁ = w₀ + alf₁ t

      w₁ = α₁ t

we replace

     w₂ = r₁ / r₂ (α₁ t)

     w₂ = 0.020 / 0.25 7.5 t

     w₂ = 0.6 t

therefore,

     α₂ = 0.6 rad /s²

b) let's reduce to the SI system

     w₂ = 75 rpm (2π rad / 1 rev) (1min / 60s) = 7.854 rad / s

We clear the equation and calculate

     t = w₂ / alf₂

     t = 7.854 / 0.6

     t = 13.1 s

hello, i am papaguy.

i have found an answer to your question but use it as information.

information: because weak acids/bases have low concentration of hydrogen ions, the addition of water has a large impact on the ph. 2. a difference in 1 unit is a 10x difference in concentration for example; a liquid with ph of 3 is 10x more acidic than a liquid with a ph of 4. therefore, a liquid with a ph of 3 is stronger.

best of luck!

the minimum amperage that the current in this wire would have to have so that its weight is completely supported by the magnetic force due to earth's field, assuming that no other forces except gravity act on it