subject
Physics, 21.11.2019 03:31 annarain2004

A50.0 nf air-filled parallel plate capacitor is connected in series with a 2.85 kn resistor and a battery of emf 36.0 v. (a) determine the final charge on the capacitor. (b) once the capacitor is fully charged and there is no current in the circuit, a sheet of plastic with a dielectric constant of 2.60 is introduced in the gap between the plates of the capacitor, completely filling the gap. if the area of each plate is 0.275 m what is the electric field inside the plastic immediately after it is inserted (before there is any change in the charge on the plates of the capacitor)? n/c (c) take a moment to think about why current starts to flow after the plastic is inserted and apply the loop rule to find a round trip potential difference equation for the circuit just after the plastic is inserted. determine the initial current through the resistor immediately after the plastic is inserted. ma (d) determine the final charge on the positive plate of the capacitor with the dielectric additional state

ansver
Answers: 1

Other questions on the subject: Physics

image
Physics, 22.06.2019 05:00, damientran
The image below shows numerous volcanic mountains in the pacific northwest. what is the most likely cause of the volcanic and earthquake activity in this region?
Answers: 2
image
Physics, 22.06.2019 05:20, cwsmith8026
Very large accelerations can injure the body, especially if they last for a considerable length of time. one model used to gauge the likelihood of injury is the severity index ( ), defined as =/ . in the expression, is the duration of the accleration, but is not equal to the acceleration. rather, is a dimensionless constant that = the number of multiples of that the acceleration is equal to. in one set of studies of rear-end collisions, a person's velocity increases by 13.7 km/h with an acceleration of 36.0 m/s2 . let the + direction point in the direction the car is traveling. what is the severity index for the collision?
Answers: 1
image
Physics, 22.06.2019 09:40, dakshshberry
Asatellite component is in the shape of a cube with 10cm edges, has an evenly distributed mass of 2 kg and one bolt hole at each of four corners. if the maximum predicted random vibration environment is 10 grms, what bolt size would be a good choice for restraint? what other factors might drive bolt size besides force/stress?
Answers: 2
image
Physics, 22.06.2019 11:00, arugg2k24
What is the rate of 12 liters of water moving through a water hose in 4.0 minutes?
Answers: 1
You know the right answer?
A50.0 nf air-filled parallel plate capacitor is connected in series with a 2.85 kn resistor and a ba...

Questions in other subjects:

Konu
Mathematics, 18.04.2021 23:50
Konu
Mathematics, 18.04.2021 23:50
Konu
Mathematics, 18.04.2021 23:50