Physics, 19.11.2019 05:31 BLUE1700

Part c for the next two parts we will use the following relationship between the input and output voltage which you should have found in solving for part b: vo(t)=vin(1−e−αt(cos(βt)+αβsin(β , where α=11389 rad/sec and β=27553 rad/sec and time is now measured in seconds. what is the largest dc voltage, vin that we can use at the input without causing the op-amp to saturate? enter your answer with appropriate units and round your answer to three significant digits. warning: in order to find when vo(t) reaches its peak value you will need to solve dvodt=0 . the output voltage has many local maxima and minima. make sure you get the right one. a plot of vo(t) vs. t will be in guiding you to the right solution.

Answers: 2

Show answers

Other questions on the subject: Physics

Physics, 21.06.2019 16:00, amoakoh800003

As shown in fig. p3.64, a closed, rigid tank fitted with a fine-wire electric resistor is filled with refrigerant 22, initially at 2108c, a quality of 80%, and a volume of 0.01 m3. a 12-volt battery provides a 5-amp current to the resistor for 5 minutes. if the final temperature of the refrigerant is 408c, determine the heat transfer, in kj, from the refrigerant.

Answers: 1

continue

Physics, 22.06.2019 17:00, davinedmcneal

If you wanted to move an electron from the positive to the negative terminal of the battery, how much work w would you need to do on the electron? enter your answer numerically in joules.

Answers: 1

continue

Physics, 22.06.2019 20:30, cupcake3103670

Aball is thrown from the top of a building with an initial velocity of 21.9 m/s straight upward, at an initial height of 51.6 m above the ground. the ball just misses the edge of the roof on its way down, as shown in the figure. (a) determine the time needed for the ball to reach its maximum height. (b) determine the maximum height. (c) determine the time needed for the ball to return to the height from which it was thrown, and the velocity of the ball at that instant. (d) determine the time needed for the ball to reach the ground. (e) determine the velocity and position of the ball at t = 5.35 s.

Answers: 1

continue

Physics, 22.06.2019 21:10, lilyclairehutson

For the below questions, consider a consumer that consumes two goods, x and z with the following utility function. u with bar on top space equals space x to the power of 1 third end exponent z to the power of 2 over 3 end exponent suppose initial values for income and the prices of goods x and z are y equals 90, p subscript x equals space 10, and p subscript z equals 15 respectively, then the price of good x falls to syntax error from line 1 column 89 to line 1 column 100. unexpected '\'.. what is the magnitude of the total effect

Answers: 3

continue

You know the right answer?

Part c for the next two parts we will use the following relationship between the input and output vo...