Physics, 07.01.2020 03:31 jalalblal

What is the differences between up milling and down milling?

Answers: 2

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 21:40, lottie2306

Engines for propeller-driven aircraft are limited in their maximum rotational speed by the fact that the tip speed of the propeller must not approach the speed of sound in air (mach i). taking 6 ft as a typical diameter for a propeller of a light airplane and 1100 fils as the speed of sound, find the upper limit on the rpm (revolutions per minute) of the propeller shaft.

Answers: 3

continue

Physics, 23.06.2019 00:30, oldless504

What practical value did astronomy offer to ancient civilizations?

Answers: 2

continue

Physics, 23.06.2019 06:00, merry69

Gravity is pulling an object into the sun. the closer the object gets to the sun, the greater the gravitational force that acts on the object, increasing its acceleration. a line graph plotting the speed of the object against time would have which shape? a: straight line of positive slope b: curved line that slopes upward c: curved line that slopes downward d: straight line of negative slope

Answers: 3

continue

Physics, 23.06.2019 08:00, skyvargasov9cad

Hunter is in lab. he clears a spot on his lab bench to start working. he also puts his lab coat and goggles on. he then identifies where all of the safety equipment is. he notices his station is next to the fume hood, which ventilates the chemicals stored there. the noise of the fume hood was bothersome, so hunter turned it off. which could be an error in his set-up? he should not turn off the fume hood. he should wait to put on his coat until after the directions are given. he should wait to put on his goggles until after the directions are given. he should not sit next to the fume hood.