Part c
it's time to make the ice pieces. for ice piece 1, place 2 teaspoons of water into one...
Physics, 15.11.2019 07:31 kristygodwin
Part c
it's time to make the ice pieces. for ice piece 1, place 2 teaspoons of water into one of the spaces in the ice cube tray. to
make ice piece 2, place 2 teaspoons of water into the sealable plastic bag. carefully squeeze as much of the air out of the
bag as possible without spilling any water. then seal the bag. place the sealed bag on a flat surface in the freezer. place
the ice cube tray in the freezer at the same time. leave both in the freezer for four hours. record the start time and the
time when you can remove the ice.
Answers: 3
Physics, 22.06.2019 07:00, lilpeepxliltracy
Aball has an initial velocity of 3 m/s. if there is no friction, what is the highest it could roll?
Answers: 1
Physics, 23.06.2019 01:30, kaylaamberd
The ideal gas model is valid if which of the following conditions is true? the gas density is low. the gas density is high. the temperature is low. the temperature is high. the gas density and the temperature are low. the gas density and the temperature are high. the gas density is high and the temperature is low. the gas density is low and the temperature is high.
Answers: 3
Physics, 23.06.2019 03:10, stotherow5
You have been hired to design a spring-launched roller coaster thatwill carry two passengers per car. the car goes up a 10-m highhill, then descends 15m to the track's lowest point. you'vedetermined that the spring can be compressed a maximum o 2.0m andthat a loaded car will have a maximum mass of 400kg. for safetyreasons, the spring constant should be 10% larger than the minimumneeded for the car to just make it over the top. a) what spring constant (k) should you specify ? b) what is the maximum speed of a 350 kg car if the spring iscompressed the full amount.
Answers: 2
Mathematics, 02.10.2020 23:01
Mathematics, 02.10.2020 23:01
Mathematics, 02.10.2020 23:01
Mathematics, 02.10.2020 23:01
Chemistry, 02.10.2020 23:01