Physics, 10.11.2019 03:31 helpmeplzandty

Consider a head-on elastic collision between two objects. object 1, which has mass m1, is initially in motion, and collides head-on with object 2, which has mass m2, and is initially at rest. which of the following statements about the collision are true? a) |p1,final| < |p1,initial|b) if m1 > > m2, then the final speed of object 2 is less than the initial speed of object 1.c) if m2 > > m1, then |delta p1| > |delta p2|d) if m2 > > m1, then the final speed of object 1 is greater than the final speed of object 2.e) p1,initial = p1,final + p2,final

Answers: 1

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 15:50, ksiandua07

An object with initial temperature 130 ∘ f is submerged in large tank of water whose temperature is 50 ∘ f . find a formula for f ( t ) , the temperature of the object after t minutes, if the cooling constant is k = − 0.2 . remember newton's law of cooling (the rate of change of temperature with respect to time is equal to k times the difference between the temperature of the object and the surrounding temperature) ! : )

Answers: 1

continue

Physics, 22.06.2019 16:50, justkevin1231

Aresistor with an unknown resistance is connected in parallel to a 9 ω resistor. when both resistors are connected in parallel to an emf source of 21 v, the current through the unknown resistor is measured with an ammeter to be 4 a. what is the resistance of the unknown resistor? answer in units of ω.

Answers: 3

continue

Physics, 22.06.2019 18:30, raywalker3410

Adisk with a radius of r is oriented with its normal unit vector at an angle q with respect to a uniform electric field. which of the following would result in an increase in the electric flux through the disk? check all that apply? a. increasing the area of the disk b. decreasing the given orientation angle of the disk c. decreasing the strength of the electric field d. increasing the given orientation angle of the disk, but not exceeding an angle of 90

Answers: 1

continue

Physics, 22.06.2019 20:50, dorkygirl

An ideal otto cycle has a compression ratio of 8. at the beginning of the compression process, air is at 95 kpa and 27°c, and 750 kj/kg of heat is transferred to air during the constant-volume heat-addition process. assuming constant specific heats at room temperature, determine (a) the pressure and temperature at the end of the heat-addition process, (b) the net work output, (c) the thermal efficiency, and (d) the mean effective pressure for the cycle. (4390 kpa, 1730 k; 423 kj/kg; 56.4%; 534 kpa)

Answers: 1

continue

You know the right answer?

Consider a head-on elastic collision between two objects. object 1, which has mass m1, is initially...