subject
Physics, 04.11.2019 21:31 maddycat4005

Refrigerant-134a enters a diffuser steadily as saturated vapor 500 kpa with a velocity of 170 m/s, and it leaves at 600 kpa and 50◦c. the refrigerant is gaining heat at a rate of 2.5 kj/s as it passes through the diffuser. if the exit area is 75 percent greater than the inlet area, determine (a) the exit velocity and (b) the mass flow rate of the refrigerant.

ansver
Answers: 1

Other questions on the subject: Physics

image
Physics, 21.06.2019 22:30, mirellaenriquez5529
Follow these directions and answer the questions. 1. shine a pencil-thin beam of light on a mirror perpendicular to its surface. (if you don't have a laser light as suggested in the video, you can make a narrow beam from a flashlight by making a cone from black construction paper and taping it over the face of the flashlight.) how does the light reflect? how does the relationship of incident to reflected ray relate to the reflection of water waves moving perpendicular to a barrier? 2. shine a pencil-thin beam of light on a mirror standing on a sheet of paper on the table (or floor) so that you can mark the incident ray and reflected ray. (you can support the mirror from the back by taping it to a wooden block.) 3. mark a line on the paper representing the reflective surface. (the reflective surface of a mirror is usually the back edge.) 4. draw a dashed line perpendicular to the mirror surface at a point where the incident and reflected ray meet. this perpendicular is called a normal to the surface. 5. measure the angles between the rays and the normal. the angle of incidence is the angle formed by the incident ray and the normal to the surface. the angle formed by the reflected ray and normal is called the angle of reflection (r). what is the angle of incidence? what is the angle of reflection? 6. repeat for several different angles. (see report sheet for details.) what appears to be the relationship between the angle of incidence and angle of reflection? in science 1204, what was the relationship for these two angles made by the reflection of waves in a ripple tank? 7. roll a ball bearing so that it hits a fixed, hard surface (a metal plate) at several angles (including head-on). observe the way in which the ball bearing reflects. what generalization can you make about how a ball bearing reflects from a wall? have you proved that light can only behave like a wave?
Answers: 1
image
Physics, 22.06.2019 03:00, trinitieu66
Ahot-air balloonist, rising vertically with a constant speed of 5.00 m/s releases a sandbag at the instant the balloon is 40.0 m above the ground. after it is released, the sandbag encounters no appreciable air drag. compute the velocity of the sandbag at 0.250 s after its release.
Answers: 2
image
Physics, 22.06.2019 18:00, emory238
What structural formula represents 4 electrons shared between two atoms?
Answers: 1
image
Physics, 22.06.2019 20:00, chantelljenkins2
Aturntable that spins at a constant 74.0 rpm takes 3.10 s to reach this angular speed after it is turned on. find its angular acceleration (in rad/s2), assuming it to be constant, and the number of degrees it turns through while speeding up.
Answers: 2
You know the right answer?
Refrigerant-134a enters a diffuser steadily as saturated vapor 500 kpa with a velocity of 170 m/s, a...

Questions in other subjects: