Which are the factors on which kinetic energy depends ?

i think its

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

so here is the information for current research:

-nrel's geothermal analysts, scientists, and engineers perform a full range of research from developing advanced methods of locating and accessing geothermal resources to exploring innovative technologies to extract and produce clean energy from the heat of the earth

and here is the information for the technology of geothermal energy:

-it's clean and sustainable

-resources of geothermal energy range from the shallow ground to hot water and hot rock found a few miles beneath the earth's surface, and down even deeper to the extremely high temperatures of molten rock called magma

-almost everywhere, the shallow ground or upper 10 feet of the earth's surface maintains a nearly constant temperature between 50° and 60°f (10° and 16°c)

-geothermal heat pumps can tap into this resource to heat and cool buildings

-a geothermal heat pump system consists of a heat pump, an air delivery system (ductwork), and a heat exchanger-a system of pipes buried in the shallow ground near the building

-in the winter, the heat pump removes heat from the heat exchanger and pumps it into the indoor air delivery system

-in the summer, the process is reversed, and the heat pump moves heat from the indoor air into the heat exchanger

-the heat removed from the indoor air during the summer can also be used to provide a free source of hot water