Physics, 29.10.2019 05:31 sarahjunexx

Ahole is punched at a in a plastic sheet by applying a 660-n force p to end d of lever cd, which is rigidly attached to the solid cylindrical shaft bc. design specifications require that the displacement of d should not exceed 15 mm from the time the punch first touches the plastic sheet to the time it actually penetrates it. determine the required diameter of shaft bc if the shaft is made of a steel with g.

Answers: 2

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 00:40, naomicervero

The rigid beam is supported by the three suspender bars. bars ab and ef are made of aluminum and bar cd is made of steel. if each bar has a cross-sectional area of 450 mm2, determine the maximum value of p if the allowable stress is (σallow)st = 200 mpa for the steel and ( σallow)al = 150 mpa for the aluminum. est = 200 gpa and eal = 70 gpa.

Answers: 1

continue

Physics, 22.06.2019 02:30, bellamore

Awave travels at a speed of 5.2 m/s. if the distance between crests is 0.40 m, what is the frequency of the wave? use f=v/wavelength a. 13 hz b. 2.1 hz c. 0.077 hz d. 5.6 hz

Answers: 1

continue

Physics, 22.06.2019 04:30, MadisonUpky9652

Which of the following are not typically included in the periodic table? a. atomic mass b. element symbol c. isotopes d. number of electrons

Answers: 2

continue

Physics, 22.06.2019 10:00, blackjack73

The rocket is fired vertically and tracked by the radar station shown. when θ reaches 66°, other corresponding measurements give the values r = 32700 ft, r¨ = 85 ft/sec2, and θ˙ = 0.019 rad/sec. calculate the magnitudes of the velocity and acceleration of the rocket at this position.

Answers: 3

continue

You know the right answer?

Ahole is punched at a in a plastic sheet by applying a 660-n force p to end d of lever cd, which is...