Physics, 23.10.2019 18:50 kprincess16r

You work in a machine design department and need to specify the diameter of a pin that slides back and forth through a hole. the hole diameter is specified as 0.500 inch with a tolerance of ±0.010 inch. the maximum pin diameter must be 0.002 inch smaller than the minimum hole diameter. if the pin diameter has a tolerance of ±0.010 inch, what diameter, in inches, should you specify for the pin?

Answers: 2

Show answers

Other questions on the subject: Physics

Physics, 21.06.2019 18:40, Rachaeltice8810

Ten students stand in a circle and are told to make a transverse wave. what best describes the motion of the students? each student bumps the shoulder of his or her neighbor. at the exact time, all students take a step to the right. the students skip clockwise, going in a circular motion. one at a time, each student lifts his or her hands up and then down.

Answers: 1

continue

Physics, 21.06.2019 19:00, trinityhayes347

Fill in the blank. the number of each type of element in the compound (other than 1) is represented by a small number to the right of the element symbol.

Answers: 1

continue

Physics, 21.06.2019 19:30, ricesonice5

11. you want to calculate the displacement of an object thrown over a bridge. using -10 m/s2 for acceleration due to gravity, what would be the total displacement of the object if it took 8 seconds before hitting the water?

Answers: 1

continue

Physics, 22.06.2019 05:00, eshaesmot12345

Which car has the most kinetic energy? a. a car of mass 1000 kg with a speed of 3 m/s b. a car of mass 2000 kg with speed 7 m/s c. a car of mass 1000 kg with speed 7 m/s d. a car of mass 2000 kg with speed 3 m/s

Answers: 1

continue

You know the right answer?

You work in a machine design department and need to specify the diameter of a pin that slides back a...