Bar (1) has a length of l1 = 2.50 m, and bar (2) has a length of l2 = 0.65 m. initially, there is a gap of d = 3.5 mm between the rigid plate at b and bar (2). after application of the loads p to the rigid plate at b, the rigid plate moved to the right, stretching bar (1) and compressing bar (2). the normal strain in bar (1) was measured as 2,740 μm/m after the loads p were applied. determine the normal strain produced in bar (2).

Which of the following represents an upright image? a. -do b. +m c. -m d. +do

An object is 10. cm from the mirror, its height is 3.0 cm, and the focal length is 2.0 cm. what is the image height? (indicate the object orientation by including the + or - sign with the answer.) hi = cm +1.33 -1.33 +0.75 -0.75

5submission this assignment is worth 20 points total. you are required to submit the following by next lab: 1. (3 points) determine the equation for the output angular velocity ω2 = θ˙ 2 as a function of θ1, ω1 = θ˙ 1 and α. you must show all your work to receive credit. 2. (2 points) use the result of problem#1 to plot ω2 over 0 ≤ θ1 ≤ 360deg with ω1 = 360deg/sec. do this for α = {10,30}deg. show the results on the same plot and properly label the axes, title, legend. for this you can use matlab or ms excel. 3. (3 points) determine the equation for the output angular acceleration ω˙ 2 and create a plot similar to the one in problem#2. 4. (10 points) submit plots of the results (ω2 and ω˙ 2) obtained from creo/mechanism and compare them to results of problem#2 and problem#3. note that you should do these comparisons for the two cases with α = {10,30}deg. 5. (2 points) provide a brief explanation of the results. did they match? what are the implications as misalignment angle increases?