subject
Physics, 02.10.2019 05:20 22nathanieltimms

2. three students derive the following equations in which v refers to the speed(m/s), a, the
acceleration (m/s), t the time, and the subscript zero (0) means a quantity at time t = 0.
here are their equations: (a) v = v. + 2at, (b) v = v, + 1/2 ata and (c) v= vo + at. which on
these could possibly be correct according to a dimensional check, and why?

ansver
Answers: 2

Other questions on the subject: Physics

image
Physics, 22.06.2019 09:30, kaleahlove13
Suppose you increase your walking speed from 7 m/s to 13 m/s in a period of 2 s. what is your acceleration?
Answers: 2
image
Physics, 22.06.2019 12:30, decemberbooker2505
Brades exam guidelines exam instructions billing & payments & support question 6 of 20 : select the best answer for the question use this illustration to answer the question below. forms & resources al programs 9 ww linics 6. in the circuit shown in the figure above, suppose that the value of r, is 100k, and the value of r2 is 470 kq. at which of the following locations in the circuit would you measure the highest voltage with your meter? rvices 999999 a. between points b and c b. between points a and b c. between points b and e d. between points a and c eredu mark for review (will be highlighted on the review page) mend < < previous question next question
Answers: 1
image
Physics, 22.06.2019 17:50, arunamvr
Which of the following best describes internal energy? a. the difference between the kinetic and potential energies of the particles in a system b. the sum of the kinetic and potential energies of the particles in a system c. the sum of the kinetic and thermal energies of the particles in a system d. the difference between the kinetic and thermal energies of the particles in a system
Answers: 2
image
Physics, 22.06.2019 18:00, maren17
Air enters a gas turbine with two stages of compression and two stages of expansion at 100 kpa and 17°c. this system uses a regenerator as well as reheating and intercooling – the intercooler returns the air to the inlet temperature. the pressure ratio across each compressor is 4 ; 300 kj/kg of heat are added to the air in each combustion chamber; and the regenerator operates perfectly while increasing the temperature of the cold air by 20°c. determine the system’s thermal efficiency. assume isentropic operations for all compressor and the turbine stages and use constant specific heats at room temperature. (0.378)
Answers: 3
You know the right answer?
2. three students derive the following equations in which v refers to the speed(m/s), a, the
a...

Questions in other subjects:

Konu
History, 22.09.2019 13:50
Konu
English, 22.09.2019 13:50
Konu
Health, 22.09.2019 13:50