subject
Physics, 01.10.2019 01:30 sindy35111

As shown in the diagram below, two mules pull on a stump that has a mass of 1,850 kg. one mule pulls with a force f1 = 10.2 kn and the other mule pulls with a force f2 = 16.0 kn. find the magnitude of the stump's acceleration in m/s^2 if it comes out of the ground.
if the stump came out, what direction would it be moving? record the angle as a standard angle.


As shown in the diagram below, two mules pull on a stump that has a mass of 1,850 kg. one mule pulls

ansver
Answers: 2

Other questions on the subject: Physics

image
Physics, 22.06.2019 01:20, slimgemmx
An engineer designs a roller coaster so that a car travels horizontally for 152 ft, then climbs 137 ft at an angle of 34.0° above the horizontal. it then moves 137 ft at an angle of 48.0° below the horizontal. if we take the initial horizontal motion of the car to be along the +x-axis, what is the car's displacement? (give the magnitude of your answer, in ft, to at least four significant figures and give the direction of your answer in degrees counterclockwise from the +x-axis.)
Answers: 1
image
Physics, 22.06.2019 12:30, dee2970
Write a full page that sumerizes thermodynamics it’s from the website visionlearnig
Answers: 1
image
Physics, 22.06.2019 17:00, marchellepenuliar
Sawyer is studying diffraction. he draws a diagram of a plane wave to show how light waves travel. which best describes sawyer’s error? the wave fronts should be perpendicular to the direction in which the waves move. the arrow showing the direction of movement of the waves should be pointing to the left. the arrow showing the direction of movement of the waves should be pointing downward. the wave fronts should be both parallel and perpendicular to the direction in which the waves move.
Answers: 3
image
Physics, 22.06.2019 18:00, maren17
Air enters a gas turbine with two stages of compression and two stages of expansion at 100 kpa and 17°c. this system uses a regenerator as well as reheating and intercooling – the intercooler returns the air to the inlet temperature. the pressure ratio across each compressor is 4 ; 300 kj/kg of heat are added to the air in each combustion chamber; and the regenerator operates perfectly while increasing the temperature of the cold air by 20°c. determine the system’s thermal efficiency. assume isentropic operations for all compressor and the turbine stages and use constant specific heats at room temperature. (0.378)
Answers: 3
You know the right answer?
As shown in the diagram below, two mules pull on a stump that has a mass of 1,850 kg. one mule pulls...

Questions in other subjects: