subject
Physics, 30.09.2019 20:10 sash0924

Mustang sally just finished restoring her 1965 ford mustang car. to save money, she did not get a new battery. when she tries to start the car, she discovers that the battery is dead (an insufficient or zero voltage difference across the battery terminals) and so she will need a jump start. here is how she accomplishes the jump start: she connects a red jumper cable (wire) from the positive terminal of the dead battery to the positive terminal of a fully functional new battery. she connects one end of a black jumper cable to the negative terminal of the new battery. she then connects the other end of the black jumper cable to the negative terminal of the dead battery. the new battery (now in a parallel with the dead battery) is now part of the circuit and the car can be jump started. the car starter motor is effectively drawing current from the new battery. after the car with the dead battery is running, the cables can be disconnected in the reverse order that they were connected. while unhooking the jumper cables, the positive and negative cables almost touch and a spark jumps between the ends of the cables. this spark is caused by the movement of electrons through the air between the battery terminals. in what direction are the electrons traveling during the spark?

ansver
Answers: 1

Other questions on the subject: Physics

image
Physics, 21.06.2019 22:30, starreee
Acricket ball of 70g moving with a velocity of 0.5 m/s is stopped by a player in 0.5s what is the force applied to stop the ball
Answers: 1
image
Physics, 21.06.2019 23:30, ladawnrowles005
Two technicians are discussing a resistance measurement between the can-h and can-l wires. technician a says this measurement should be done with the ignition switch in the "run" position. technician b states that a measurement of 0 ohms indicates an open in the network. which technician is correct?
Answers: 3
image
Physics, 22.06.2019 02:50, antcobra
20. threshold braking in the vehicle's braking system occurs when a. the brake pedal is pushed, heel on floorboard, with full foot pressure. b. the brakes are exerting full braking power, without traction loss. c. the driver begins pushing down the brake pedal, with moderate slowdown. d. the brakes just begin to take hold with a gradual slowdown.
Answers: 3
image
Physics, 22.06.2019 10:30, SauceyNaee
Aparticle moves in the xy plane with constant acceleration. at time zero, the particle is at x = 6 m, y = 8.5 m, and has velocity ~vo = (9 m/s) ˆı + (−2.5 m/s) ˆ . the acceleration is given by ~a = (4.5 m/s 2 ) ˆı + (3 m/s 2 ) ˆ . what is the x component of velocity after 3.5 s? answer in units of m/s.
Answers: 1
You know the right answer?
Mustang sally just finished restoring her 1965 ford mustang car. to save money, she did not get a ne...

Questions in other subjects: