subject
Physics, 28.09.2019 16:20 lillyawesome28

You have a lightweight spring whose unstretched length is 4.0 cm. first, you attach one end of the spring to the ceiling and hang a 3.0 g mass from it. this stretches the spring to a length of 5.4 cm . you then attach two small plastic beads to the opposite ends of the spring, lay the spring on a frictionless table, and give each plastic bead the same charge. this stretches the spring to a length of 4.7 cm . what is the magnitude of the charge (in nc) on each bead?

ansver
Answers: 3

Other questions on the subject: Physics

image
Physics, 22.06.2019 05:30, gunnatvinson
What tightening torque should be used for a hexagonal head screw (not split-bolt) on a 250 kcmil conductor?
Answers: 3
image
Physics, 22.06.2019 11:40, johanperezpere51
Imagine that you have two balloons (or, better yet, actually inflate two balloons, if possible). create static electricity around one of the balloons by rubbing it against your hair or your sweater and then bring that balloon close to the other balloon, which has not been charged. try this with at least one other object—and for variety in the discussion, avoid using an object already described by your classmates. then, for your initial post to the discussion, answer the following questions: what happened with the two balloons?
Answers: 3
image
Physics, 22.06.2019 19:30, Bg88860709
Aspacecraft that renters the earth’s atmosphere drastically slows down. the amount of kinetic energy the spacecraft has as it reenters the earths atmosphere
Answers: 2
image
Physics, 22.06.2019 23:00, shelbybibb99
Acommon technique in analysis of scientific data is normalization. the purpose of normalizing data is to eliminate irrelevant constants that can obscure the salient features of the data. the goal of this experiment is to test the hypothesis that the flux of light decreases as the square of the distance from the source. in this case, the absolute value of the voltage measured by the photometer is irrelevant; only the relative value conveys useful information. suppose that in part 2.2.2 of the experiment, students obtain a signal value of 162 mv at a distance of 4 cm and a value of 86 mv at a distance of 5.7 cm. normalize the students' data to the value obtained at 4 cm. (divide the signal value by 162.) then calculate the theoretically expected (normalized) value at 5.7 cm.
Answers: 2
You know the right answer?
You have a lightweight spring whose unstretched length is 4.0 cm. first, you attach one end of the s...

Questions in other subjects: