The results below were obtained from a tension test. the test specimen had a diameter of 0.505 in. and a gage length of 2.00 in. at fracture, the elongation between the gage marks was 0.12 in and the minimum diameter was 0.42 in. plot the stress-strain curve and determine: the proportional limit modulus of elasticity yield stress at 0.2% offset ultimate stress percent elongation and percent area reduction. identify the material being tested (see average material properties in the back of your textbook). an identical sample is loaded to an elongation of 0.020 in. and then unloaded. how does the final length of the bar compare with its original length?
Answers: 1
Physics, 22.06.2019 05:30, mlopezmanny5722
The a992 steel rod bc has a diameter of 50 mm and is used as a strut to support the beam. determine the maximum intensity w of the uniform distributed load that can be applied to the beam without risk of causing the strut to buckle. take f. s. = 2 against bucklin
Answers: 3
Physics, 22.06.2019 09:00, montgomeryaevans
This is really important 1.which of the following prefixes represents the largest value? (2 points)gigahectorkilomilli2.which of the following types of graphs is best for plotting the mean, median, and mode of data? (2 points)bar graphbox-and-whiskercircle graphstem-and-leaf
Answers: 1
The results below were obtained from a tension test. the test specimen had a diameter of 0.505 in. a...
English, 03.07.2020 22:01
Mathematics, 03.07.2020 22:01