subject
Physics, 05.07.2019 17:10 diamondscott9297

In a physics laboratory experiment, a coil with 200 turns enclosing an area of 12cm2 is rotated in 0.040 s from a position where its plane is perpendicular to the earth’s magnetic field to a position where its plane is parallel to the field. the earth’s magnetic field at the lab location is 6.0×10−5t. (a) what is the total magnetic flux through the coil before it is rotated? after it is rotated? (b) what is the average emf induced in the coil?

ansver
Answers: 1

Other questions on the subject: Physics

image
Physics, 21.06.2019 22:00, sophiamoser
In a wind tunnel the speed changes as the cross sectional area of the tunnel changes. if the speed in a 6' x 6' square test section is 100 mph, what was the speed upstream of the test section where the tunnel measured 20' x 20'? use conservation of mass and assume incompressible flow. conservation of mass requires that as the flow moves through a path or a duct the product of the density, velocity and cross sectional area must remain constant; i. e., that ova-constant. a model is being tested in a wind tunnel at a speed of 100 mph if the flow in the test section is at sea level standard conditions, what is the pressure at the model's stagnation point? (a) the tunnel speed is being measured by a pitot-static tube connected to a u- tube manometer. what is the reading on that manometer in inches of water? (b) at one point on the model a pressure of 2058 psf is measured. what is the local airspeed at that point?
Answers: 2
image
Physics, 22.06.2019 14:40, kellypechacekoyc1b3
Asolid cylinder and a cylindrical shell have the same mass, same radius, and turn on frictionless, horizontal axles. the cylindrical shell has light-weight spokes connecting the shell to the axle. a rope is wrapped around each cylinder and tied to blocks of equal masses that are held the same height above the ground. both blocks are released simultaneously. the ropes do not slip. which block hits the ground first? or is it a tie?
Answers: 3
image
Physics, 22.06.2019 15:20, mjwaple57
Acarpenter builds an exterior house wall with a layer of wood 2.9 cm thick on the outside and a layer of styrofoam insulation 2.3 cm thick on the inside wall surface. the wood has k=0.080w/(m⋅k), and the styrofoam has k= 0.010 w/(m⋅k). the interior surface temperature is 19.0 ∘c , and the exterior surface temperature is -15.0 ∘c . a.)what is the temperature at the plane where the wood meets the styrofoam? celsius b.)what is the rate of heat flow per square meter through this wall? /m^2
Answers: 2
image
Physics, 22.06.2019 16:00, postorivofarms
The process of predicting values that extend beyond the range of data points is called absolute value extrapolation interpolation prediction for any given: )
Answers: 2
You know the right answer?
In a physics laboratory experiment, a coil with 200 turns enclosing an area of 12cm2 is rotated in 0...

Questions in other subjects: