Physics, 03.07.2019 05:20 stormhorn5108

In a sand casting process the volume flow rate of metal into a mold is 0.02 m/( the top of the sprue has a diameter of 200 mm and a length of 500 mm. what diameter should be specified at the middle and at the bottom of the sprue to have a continuous flow (avoid aspiration)? if the reynold's number at the bottom of the sprue is greater than 20,000 what changes do you suggest (changes to the material or the mold design) in order to avoid a turbulent flow?

Answers: 2

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 12:10, JN02

Ablock having mass m slides down an inclined plane. the force of friction between the block and the inclined plane is f, the block's weight is m g, and the normal force is n. (a) draw a free – body force diagram showing the forces acting on the block. (b) write down all relevant newton’s equations for a given situation.

Answers: 1

continue

Physics, 23.06.2019 06:30, lovecats12

Acar weighs 15,000 n, and its tires are inflated to a pressure of 190kpa. how large is the area of the car's tires that are in contact with the road?

Answers: 1

continue

Physics, 23.06.2019 10:30, jumeljean123oythxy

Abig box of sausages (30 kg) are lifted from the ground to the top shelf of the freezer. if the box is lifted at a constant speed, a distance of 1.75 m, what work is done by gravity?

Answers: 1

continue

Physics, 23.06.2019 14:30, donbright100

If it takes 200 joules of energy to lift a bucket of water 3 meters in 2 seconds, how much power would be required to do the same amount of work in 5 seconds?

Answers: 1

continue

You know the right answer?

In a sand casting process the volume flow rate of metal into a mold is 0.02 m/( the top of the sprue...