Consider that you are using an extrusion based abs printer. calculate the required heater power, total pressure drop in liquefier, and motor power for extrusion at steady state condition for deposition speed of 0.5, 1, 1.5, 3, 5, 10, and 50 mm/s and plot them on three separate graphs. use the following data m 2.16 φ = 7.4 x 10-5 (kpa)-m s-1 p 900 kg/m3 p 1500 j/kg-k di 1.8 mm し,-10 mm some required data is missing that can be found from literature.
Answers: 1
Physics, 22.06.2019 01:10, joejoefofana
Suppose that two tanks, 1 and 2, each with a large opening at the top, contain different liquids. a small hole is made in the side of each tank at the same depth 1.57 m below the liquid surface, but the hole in tank 2 has 2.49 times the cross-sectional area of the hole in tank 1. (a) what is the ratio ρ1/ρ2 of the densities of the liquids if the mass flow rate is the same for the two holes? (b) what is the ratio rv1/rv2 of the volume flow rates from the two tanks? (c) at one instant, the liquid in tank 1 is 14.9 cm above the hole. if the tanks are to have equal volume flow rates, what height above the hole must the liquid in tank 2 be just then?
Answers: 3
Physics, 22.06.2019 04:40, joneil1952
Argon is adiabatically compressed from an initial volume of 16 liters to a final volume of 2 liters. by what factor do the following quantities change? do they increase or decrease? (a) the rms speed (b) the thermal energy of the gas (c) the molar specific heat cv (d) the pressure
Answers: 3
Physics, 22.06.2019 12:30, lmolder1329
Consider a 1000 w iron whose base plate is made of 0.5 cm thick aluminum alloy 2024-t6 (ρ = 2770 kg/m3 and cp = 875 j/kg°c). the base plate has a surface area of 0.03 m2. initially, the iron is in thermal equilibrium with the ambient air at 22°c. assuming 90% of the heat generated in the resistance wires is transferred to the plate, determine the minimum time needed for the plate temperature to reach 200°c.
Answers: 1
Consider that you are using an extrusion based abs printer. calculate the required heater power, tot...
Biology, 29.06.2019 07:40
Mathematics, 29.06.2019 07:40
Mathematics, 29.06.2019 07:40
Mathematics, 29.06.2019 07:40
History, 29.06.2019 07:40